Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Link b/w router and switch

I am useing 2600 series router and trying to link it with a 2950 switch,

2950 switch is attached with a internet connection & layer 3 switches, 2600 series router is connecting with 2950 at the client permises, what will be the port configuration at both 2950 & 2600 series devices,

currently i configure sw mod trunk at 2950,

and IP at the fastethernet port of 2600 series router.

But when ever i try to telnet the router it cannot telnet

3 REPLIES
Purple

Re: Link b/w router and switch

It might help if you posted the configs you are using.

Paresh

New Member

Re: Link b/w router and switch

Its a Switch port configuration

interface FastEthernet0/13

description FREE

switchport mode trunk

end

Its a Router port configuration

interface FastEthernet0/1

ip address IP-Address 255.255.255.0

duplex auto

speed auto

end

Purple

Re: Link b/w router and switch

What VLAN are the devices from which you wish to telnet to the router ?

You need to configure the router as follows:

interface fastethernet0/1.10

encapsulation dot1q

ip address

Where VLAN is the VLAN you want to get to the router from ...

Pls do remember to rate posts.

Paresh

116
Views
0
Helpful
3
Replies
CreatePlease login to create content