If thats a cisco Router or switch, you can use "Show interfaces" command and check the traffic rate in bits/sec, (exponential average aith a time constant of 5 min's), that should give you a fair idea of link utillization.
Enable IP accounting, and check the Host IP address which are sending the most No. of frames over the wire.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...