Linksys srw2048 unable to update firmware via xmodem (using hyperterm)
I have three srw2048 series switches at my new job. One updated fine via the web interface the other two (after I found a windows machine to use the web interface) looked as though they were uploading the new file but after a reboot I was still on the old verison. So I broke out the console cable. What I have done is to Download Software to the switch (option 1) this kicks me over into xmodem. Once I am in xmodem I choose to send a file (the latest rom) using the 1K Xmodem protocol it immediately gives me retries and errors until it reaches a threshold that ends the session. During this whole process zero k is transferred.
Boot Version 1.0.0.04
Software Version 220.127.116.11
Hardware Version 00.03.10
The only thing I can think is that I must need older files to upgrade to an intermediary version before loading the latest 1.22 rom file.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...