Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LL T1 & HDSL

I have a new turnup of a LL T1. Unforunately, we were short on facilities so the LEC used a HDSL NIU so that we could run this T1 circuit over a single pair. This weekend I tested this new circuit. The line came up and data was passing properly, but when I would send data across the line the round trip delay increases by thousands and renders the circuit relatively useless. Another engineer recommended I configure my WIC for HDSL, but the circuit is supposed to be a full T1. Anyone aware of this issue? TIA

1 REPLY
Community Member

Re: LL T1 & HDSL

My fault, I configured the channel-groups wrong. I forgot the 1-24 entry.

115
Views
0
Helpful
1
Replies
CreatePlease to create content