I'm working on configuring low latency queuing on our 7206vxr router. I'd like to give preference to delay sensitive traffic. I've done so on our T1's
class-map match-any latency_sensitive_traffic
match protocol telnet
match protocol ssh
match protocol vpn
match protocol ipsec
priority 384 51200
ip address 188.8.131.52 255.255.255.0
ip load-sharing per-packet
service-policy output latency
However I can not apply this same service-policy to the atm interface. I realize atm is a different beast, hense my problems, but don't know where to begin. The reading I have done says that QoS policies can be applied at different places, interface, sub-interface or pvc. I've tried the interface and sub-interface, reconfiguring the policy map differently. Right now my atm neophite status is limiting my understanding and options.
Does anyone have good links/example reguarding QoS and atm?
in the original cfg, you have service-policy output latency under ATM interface and in latest post you have 'service-policy input limit_file_sharing ' . This policy doesn't exist in the cfg posted above FYI.
When you apply the service-policy to the interface, or PVC and there is a problem IOS will output a warning about insufficent bandwidth, etc. Are you seeing any errors? If you are telented into the router do a 'term mon' before applying the command. Also I see there is no vbr-rt/vbr-nrt/cbr/etc command applied to atm PVC to define the bandwidth over this PVC. This is needed when doing LLQ so LLQ uses the correct amount of bandwidth. I've had issues with service-policys not being applied when the vbr-rt/vbr-nrt, etc settings were not configured.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.