But usually the name of the device does not change, unless might be is the device had been discovered through one interface, the ani process will try to resolve to that interface. And then most probably the database was deleted and in the new discovery the device was discovered with or through a new interface. The ANI process will try to resolve to the new interface discovered.
I dont think there should be anyother think. About device name getting changed in RME. It is posible that the device was added with one name and in campus the device was discovered with a different name. And if you have or done a syn to ani database or import devices from ANI server.
direct answere should not happen, unless anything done.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...