I have 3 sites. 1 hub 2 spokes on HSRP. The HSRP sites are connected to each other over Fast E and it works. The client wants to load BAL outbound from the HSRP sites. Playing with metrics is not an option E2 route.
I am wondering if i take out bandwidth and put a cost of 1 on one PVC and 2 on the other PVC and in under ospf i put max paths-2. The client wants the load BAL to be on spare serial interfaces. So i will connect with a cross over from one HSRP router to the 2nd HSRP router and I will assign an ip address to each side of the serial link. I will add the serial crossover network under OSPF.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...