Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

load-balance bridged protocols between 3600 & dual-6500s

I have dual 6513's(set-up for resilience) at my core. At this time I route IP,IPX and bridge( the OSLAN protocol, there is only one bridge-group, on my network(for an ICL mainframe)). I wish to connect a link from my Aggregation routers (3640s) to each 6513. I can and works for IP and IPX but I get STP issues when both ports have bridge-group 1 enabled.

I have tried different bridge-groups but as I have only one interfaced M/F on one VLAN, I can't have two bridge-groups together on the same VLAN.

6513\

|||| 3640--2600

6513/

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: load-balance bridged protocols between 3600 & dual-6500s

Here's the link to the spanning tree support page. Take a look at the troubleshooting section. might help.

http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Technologies:Spanning_Tree&viewall=true

1 REPLY
Silver

Re: load-balance bridged protocols between 3600 & dual-6500s

Here's the link to the spanning tree support page. Take a look at the troubleshooting section. might help.

http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Technologies:Spanning_Tree&viewall=true

93
Views
0
Helpful
1
Replies