Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Load Balance on Tunnel and Fiber

Hello all,

How can I do Load Balance with two links in my router 3600? (Tunnel over Radio and Fiber).

I can have in both links IP or Frame-Relay encapsulation, and I want equal load balance de traffic and when one of the links goes down the other must assume all the traffic.

Tks,

Danilo Vido

AceNet do Brasil

55 1133650531

1 REPLY
Bronze

Re: Load Balance on Tunnel and Fiber

The router will automatically load balance over, up to 4, equal cost paths. For OSPF you can set the cost, if necessary, with eigrp you may have to change the bandwidth/delay parameters on the interface.

96
Views
0
Helpful
1
Replies
CreatePlease to create content