0 output buffer failures, 0 output buffers swapped out
Like you can see, I am having a lot of traffic into interface Fast Ethernet 0/23 and a lot of CRC and input errors, and into interface Fast Ethernet 0/24 I am having just a little traffic and 0 CRC and 0 input errors, anybody knows like I can solve this problem ?
Check duplex and speed settings on the other side of this connections, ensure they match. Swap out ports, and push something new to this port, clear counters, push some data across the port. Your input level is not above acceptable use, just over .1 megabytes a second. Put the other side of the connection under the microscope.
Your input error on F0/23 is little high over .02%, and CRC is very high (way over one per million). f0/24 is fine. You need to check on the other end that's connected to f0/23. f0/23 is set for 100/full, and I agree that you need to check the speed and duplex port setup that connected to f0/23 at the other end. if the setup correctly, check the cable. The interface counter has never been cleared, so it's hard to tell about the CRC, when the interface frist come up, it may also create CRC too. The traffic on f0/23 may cause by errors.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...