Hello, i need help, i called cisco support and for 3 days they could not help me
I have 2 2660 routers , 2 different ISP's, 2 offices. RTR1 for office1 and ISP1. RTR2 for office 2 and ISP2. ISP's and interoffice connection is T1. Ext ip of ISP1 is 220.127.116.11, ISP2 is 18.104.22.168. Office (RTR1) lan is 192.168.1.0, office2 (RTR2) lan is 192.168.7.0. interconnection is .6.1(serial1) and .6.2(serial1). I have a server in office1 192.168.1.13 and ip nat 192.168.1.13 22.214.171.124 works fine, office 2 ipnat 126.96.36.199 192.168.1.13 does not work. RTR1 config is ip route 0.0.0.0 0.0.0.0 188.8.131.52, but when i add ip route 0.0.0.0 0.0.0.0 serial1 RTR1 nat fails and RTR2 works, when i remove the added route RTR1 work RTR2 fails for email server and load shring is removed. So here is my question, How can i make sure that if request comes from RTR1 it goes back to RTR1 and same for RTR2 when i enable load balancing. Another words: You have a room with 2 doors (doorA and doorB). I f person enters room using doorA then person should exit using doorA and same goes for doorB. But if people already inside the room they have a choice of doorA or doorB whotever is closer(balancing). I do not want to use BGP or EBGP or IBGP. the protocol i use is rip, redistribute connected, ip classless. Please advice if i need a switch or create a VLAN. I would like to see an example if possible. How can i make it work?, may be i should use some other products? Please advice.HELP.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...