I have 2 links on my 1751 router one serial link connected to serial interface and the other is wireless link connected to ethernet port. How can I have load balancing between these two links, I will be use default routes for both the links.
Assuming CEF is enabled (should be by default), traffic will be load balanced between the two routes. By default CEF will do per session load sharing (source IP/Dest IP). If you want do find out which one of the two next hop is used by any src/dst address, use the following command:
show ip cef exact-route
Hope this helps,
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) firstname.lastname@example.org México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
As long as the routing protocol sees both routes as equal cost, and installs them in the routing table... You may have to adjust the delay, bandwidth, or cost on a serial link/ethernet link pair to get both routes installed in the routing table.
If you're using statics, you don't need to worry about it. If you're using eigrp, you use the bandwidth and delay commands under the interface configuration mode. For other routing protocols, you would use the metric configuration commands under the interface configuration mode.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.