10-09-2002 10:01 AM - edited 03-02-2019 01:57 AM
I have two t1's going to the same site. I would like to have traffic go across both, right now all the traffic is going across one of the t's. I am running ospf.
Each T1 goes into a different router on each side, if I do a show ip route to a subnet to the site from my side. the metric is the same. The network looks like this Router ---->T1-----> Router Router ---->T1-----> Router . I have played with the ospf cost command but I can't acheive any load balancing across both it always takes just one path. Thanks
10-09-2002 03:59 PM
This is your design:
site_a router1---T1---router2 site_b
site_a router3---T1---router4 site_b
Are you using per packet or per destination load balancing? Have you used the commands maximum-paths in conjunction with the ip ospf cost?
It may help to post the config.
Steve
10-10-2002 05:54 AM
That is correct. I am using per destination load balancing. I have not used the maximum paths command.
10-10-2002 06:26 AM
Can you enter the max paths and see what happens.
Steve
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: