Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load Balancing with Multicast

Hi Guys, We are having two equal cost paths and facing problem while configuring ip multicast with load balancing.We are using 2610 and 1750 series routers at diffrent ends.

Thanks in advance.

Pushpender

1 REPLY
New Member

Re: Load Balancing with Multicast

Hi.

You are probably having problems due to RPF. You have to configure a tunnel between the 2 routers and enable PIM on it. The preferred route for both routers to reach each other should be through the tunnel. By doing this when the routers perform RPF check, they will succeed, even though the packets are effectively using both paths.

Hope this helps.

NM

107
Views
0
Helpful
1
Replies
CreatePlease login to create content