Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load Balancing

How i can configure load balancing betwen 2 serial line (1 T1 and 1 64Kbps) and at the same time if the T1 serial link goes down the 56Kbps line stay up..

1 REPLY
noc
New Member

Re: Load Balancing

if this is an internet connection you have far less options than if this is a wan connection to another router you control (i.e. a point to point setup)

For internet access, use floating static routes, for

point to point links run EIGRP and mess with variance etc, to keep a failover scenario in place based on routing advertisements. Your Dialer can be kept up, by matching an route or a protocol type

117
Views
0
Helpful
1
Replies
CreatePlease to create content