hi,
is there a possibility to change the load-interval parameter on an fr-subinterface from 5 min to e.g. 30 sec.
vrf-test-3640#pvc 16
PVC Statistics for interface Serial0/0 (Frame Relay DTE)
DLCI = 16, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0.1
input pkts 40737 output pkts 43753 in bytes 5380563
out bytes 5778402 dropped pkts 81859 in pkts dropped 0
out pkts dropped 81859 out bytes dropped 10805388
late-dropped out pkts 81859 late-dropped out bytes 10805388
in FECN pkts 0 in BECN pkts 0 out FECN pkts 0
out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 15 out bcast bytes 4986
5 minute input rate 62000 bits/sec, 59 packets/sec
5 minute output rate 62000 bits/sec, 59 packets/sec
pvc create time 00:14:48, last time pvc status changed 00:14:48
cir 125000 bc 6000 be 0 byte limit 750 interval 48
mincir 60000 byte increment 750
pkts 43791 bytes 5783418 pkts delayed 43784 bytes delayed 5782316
shaping active
traffic shaping drops 0
Queueing strategy: fifo
Output queue 40/40, 81962 drop, 43849 dequeued
vrf-test-3640#