Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Load Sharing/Bridge

I'm currently using cisco 7206 router configured as bridge, I have two E1 lines available but only can use 1 leased line at a time, is there anyone can assist me to configure the router as bridge and use these two lines at the same time.

1 REPLY
New Member

Re: Load Sharing/Bridge

If the T1s are terminating on the same device on both ends, you can bond the T1s using PPP multilink and bridge over that.

Mick.

83
Views
0
Helpful
1
Replies