03-31-2003 07:19 PM - edited 03-02-2019 06:17 AM
Hi
We have a cisco 2610 Router with dual wic's.
Is there any sample config which supports Loadbalancing with two t1's.
and support failover between these two t1s.
Thanks
03-31-2003 08:16 PM
The link below explains the alternatives for parallel T1/E1 connections which might help you decide which one should you use. You can find the configuration guidelines for these alternatives on a separate documentation.
http://www.cisco.com/en/US/products/hw/modules/ps2033/products_white_paper09186a0080091d4b.shtml
HTH.
03-31-2003 09:36 PM
Will both links terminate on the same routers on the A & B side ?
What routing protocol are you using ?
04-01-2003 10:38 AM
both the T1 connections terminate to the same router (Cisco 2610) .
04-01-2003 03:00 PM
what routing protocol are you running ? and what version of IOS. ?
04-02-2003 06:02 AM
If your routers are not stressed for CPU cycles, the cleanest and easiest load sharing solution is to configure multilink PPP. Just be careful because MLPPP does consume more CPU cycles than other approaches. You will also find varying levels of support in different IOS releases, so you'll want to test thoroughly before going into production (but, of course, you would do that regardless of the approach taken, right ?? :-)
Good luck and have fun!
Vincent C Jones
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide