Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Loading backup config and IOS from sup-slot0: on MSFC.

We have 6509 running hybird mode, 6.1(2) CatOS and 12.1(4)E1 IOS.

How can I setup MSFC to load both IOS and configuration from sup-slot0: in case either the config on NVRAM or IOS on bootflash: corrupted?

Would "boot system flash sup-slot0:<file_name>" override the current setting or it will append to the end as on CatOS?

Would "boot config sup-slot0:<file_name>" override the current setting or it will append to the end as on CatOS?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Loading backup config and IOS from sup-slot0: on MSFC.

Detailed explanation of same is in this page:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/confg_gd/redund.htm

Regrding second question, as far as my knowledge goes, both commands will append the settings.

1 REPLY
Bronze

Re: Loading backup config and IOS from sup-slot0: on MSFC.

Detailed explanation of same is in this page:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/confg_gd/redund.htm

Regrding second question, as far as my knowledge goes, both commands will append the settings.

246
Views
0
Helpful
1
Replies
CreatePlease to create content