Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Logging interface up/down on Catalyst 6000 Native IOS

On the Catalyst 6509 with the Native IOS.

When an interface goes up or down, i haven't the message on the the "show logging".

Can i configure the Catalyst for this?

2 REPLIES
Cisco Employee

Re: Logging interface up/down on Catalyst 6000 Native IOS

Yes,

Switch(config-if)#logging event ?

link-status UPDOWN and CHANGE messages

Switch(config-if)#logging event link-status

Switch(config-if)#

New Member

Re: Logging interface up/down on Catalyst 6000 Native IOS

You may want to configure the above command suggested by richard using the interface range command which lets you configure this for a range of interface. This will save you a bunch of time :)

265
Views
0
Helpful
2
Replies
CreatePlease login to create content