Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Logging level on a C2950-24

The following is from a C2950-24:

%SPANTREE_FAST-7-PORT_FWD_UPLINK: VLAN0032 FastEthernet0/24 moved to Forwarding (UplinkFast).

And this is from a C2924-XL:

%SPANTREE_FAST-6-PORT_FWD_UPLINK: Port FastEthernet0/24 in vlan 9 moved to Forwarding (UplinkFast).

Is there a way to change the "spantree" logging level (in the C2950) from 7 to 6? I have "logging trap 6" on both switches, so level 7 messages aren't logged.

I know level 7 is meant for debug reasons, and i believe C2950 has it wrong, since this not a debug message. Of cource i can change the logging level of C2950 to 7 but that's not a right solution, since it should be used only for debug purposes.

1 REPLY
Bronze

Re: Logging level on a C2950-24

I do not think that you can set debug levels feature wise on IOS based switches. It is possible only with the set based switches.

137
Views
0
Helpful
1
Replies