I have two 3640 router running eigrp between them. I want to enable "log eigrp neighbor changes" on both router. What do i need to do to send eigrp loggging messages to my syslog server. This is what i did so far on both router
logging 10.x.x.x (Syslog server)
logging buffered Informational
router eigrp 111
log eigrp neighbor changes
Will this commands send eigrp log messages to my syslog server ? Will it consume memory on my router? Basically , I need to know if there is any impact for using "log eigrp neighbor changes ". Thanks
you have to enable "logging on" to enable the logging.eventhough if you enable these 2 commands "logging 10.x.x.x (Syslog server),logging buffered Informational " it won't send the logging messages to syslog server."logging on is must commad to enable logging.
This command won't affect router's memory.check this link
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...