Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Logical Discrepancy - VTP domain

Checking through the logical discrepancy on the CiscoWorks, I see 2 reports.

No VTP server in domain having at least 1 VTP client. This is true. We have a Switch in a remote site and this is not under the same domain as the main office. A show VTP status shows that

There is no VTP domain name and

the mode is client.

If I change this to server and give a name different from that of the main office, what effect on the network will this have? Can I do it during production hours? Or can I just leave it like it is?.

  • Other Network Infrastructure Subjects
1 REPLY

Re: Logical Discrepancy - VTP domain

Hi,

if I understand correctly, your remote switch is separated from the main office via a router. You can do anything you want with the remote switch VTP without any impact to main office in that case. VTP frames are sent only on trunk lines through VLAN1.

If you don't use VTP at all in the remote office simply set VTP mode to transparent on the remote switch and you don't have to care about VTP anymore.

If you want to use VTP on the remote site set the switch to server mode and give it a different domain name.

See VTP details in http://www.cisco.com/warp/public/473/21.html

Regards,

Milan

77
Views
0
Helpful
1
Replies