I also have this problem with 50 routers and aproximately 150 switches. The only solutions I have found so far is scripting in TeraTerm pro or a software package from Infosim (www.infosim.com). I am horrible at scripting, and I can't get in touch with anyone at infosim?
Anyone have a solution to this? We can't be the only people in the world looking to do this?!
If you implement CiscoWorks2K and also ACS, you will not only have configuration management but also user change management. How this works is that, once a user log's into your router (AAA/TACACS) and makes a change it is then updated on the CWorks2K box and logged with the USERID that changed it.
Hope this helps, ask an SE they can go into detail.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...