Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Looking for best practice Port Authentication

Hello,

I'm currently deploying 802.1x on a campus with Catalyst 2950 and 4506.

There are lots of Printers and non-802.1x devices (around 200) which should be controlled by their mac-address. Is there any "best practice" besides using sticky mac-address learning.

I'm thinking of a central place where alle mac-addresses are stored (i.e. ACS).

Another method would be checking only the first part of the mac-address (vendor OID) on the switch-ports.

Any ideas out there??

regards

Hubert

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: Looking for best practice Port Authentication

check out the following link, this provides info on port based authentication, see if it helps :

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00801cde59.html

122
Views
0
Helpful
1
Replies
This widget could not be displayed.