Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

loop command under controller E1

Anyone knows what the command 'loop' does? I can not remove it.

controller E1 0

loop

pri-group timeslots 1-31

1 REPLY
Anonymous
N/A

Re: loop command under controller E1

The loop is a command that enables

different loopbacks; local (which it

looks like is what you have configured),

network, payload, and remote (although

the exact options do depend on the HW

being used). Regardless, "no loop"

should remove the command. Make sure that you

have recent code, and ensure that the

network does not have any loops in place.

You might even disconnect the cable,

shut the interface, configure "no

loop", unshut the interface, and see

if the command is still there.

274
Views
0
Helpful
1
Replies
CreatePlease login to create content