?Half-duplex Ethernet uses a loopback circuit to detect collisions? Is this mean I need to configure a loopback interface to make collision detection work? If yes, where to set that loopback interface? On the switch? Or host? Actually, I normally don?t need to create loopback interface when I plug my computer with hub. How this works? I just don?t understand that statement.
You do not need to create any loopback interface. The book you are reading is explaining the technology in how a switch detects that there is a collision. This is a hardware mechanism in switches and we do not have to configure anything for this
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.