I have a 7204VXR that we set up, and would like to employ the loopback interface, however I am not sure how to IP it. If I use an IP that is on the same network as the primary Ethernet interface it won't bind. So do I set the loopback as the primary IP for the entire router then do unnumbered on the ethernet as well? There is little documentation or examples and many of them show the ethernet and loopback with different addresses. We are running multiple T1's and are getting ready to deploy an ATM DS-3. We want to be able supply unnumbered on all the ports..
Apply an IP address to an internal network number (10.0.0.0, 192.168, etc) to the loopback interface, then add the appropriate networks to your routing protocols. This would constitute normal operating procedures.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...