I am getting carrier transitions on my serial interface which is connected to a leased line. This is causing the serial interface to go up and down quite regularly. I beleive this is either a hardware problem or a Carrier detect problem. I wanted to do a loopback test to the csu device to check for errors. Could anyone advise me on the best way to do this and what debug commands to use, and what to look for. My router is a 2503, any advice on doing the loopback test would be appreciated.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...