Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Loos of layer 3 traffic on a frame-relay to ATM connection

When the CSU/DSU on the frame-relay side resets the connection does not come back up. The ATM side shows it up but I cannot pass layer 3 traffic.

After a shut/no shut on the ATM it comes right back up and passes traffic.

Are their any config settings that would effect this?

1 REPLY
New Member

Re: Loos of layer 3 traffic on a frame-relay to ATM connection

Might want to raise your atm idle-timeout entry. The default is 300 seconds, so raise it appropriately and monitor to see if the problem goes away.

95
Views
0
Helpful
1
Replies