07-01-2003 01:13 PM - edited 03-02-2019 08:33 AM
I am having a problem with a CISCO 2600 and it`s ethernet. I had configured it`s ip address and routing protocol with sucess. When I use the command "no shut" the interface comes up ok.... and the routes are placed on the routing table normally. But for some reason after a while the connected routes disappear! Can some one help me?
07-01-2003 04:53 PM
Does the router route once the interfaces go up before the route dissapear ?
Does the connected interfaces go down ?
Does the router still route without routes ?
Are you sure the routes are not aggregated/summarised by other routes ?
What route protocol do you use ?
Which IOS ?
07-02-2003 03:18 AM
Ok...I am loosing the connectec routes on the ethernet interface. First, the router CISCO 2600, IOS (12.0) is working fine and using EIGRP. Eventhough, I am losing these connected routes, the other routes are OK, and the interface is still up. I know the router is still routing and the routes are not summarised.
router#show ip route c , stop showing the routes and router#show ip route don't show the subnetwork configured on the ethernet interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: