Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

losing statements from the config on Cat-2980G

We hvae just upgraded the network from the Cat-5500's to the stackable Cat-2980GA's running CatOS 6.1(5). I have copied all the configs at the time of the upgrade and when we could not ping one of the Cat-2980G's, I noticed that the default route statement was missing from that switche's config.

Has anybody seen this problem on the Cat-2980G's?

Thanks.

3 REPLIES
New Member

Re: losing statements from the config on Cat-2980G

Just wanted to add that the actual lines that are missing from the config are the default gateway route lines, such as:

set ip redirect disable

set ip route 0.0.0.0/0.0.0.0 172.23.27.130

Thanks.

Purple

Re: losing statements from the config on Cat-2980G

Did you use the code that came with the 2980"s ? I have seen when you upgrade or downgrade a box losing certain config parameters , if it was an upgrade then I would say it's a code bug . You shouldn't be losing config parameters .

New Member

Re: losing statements from the config on Cat-2980G

Thanks for your response. This switch has only been in existence for about 4 month and has not been tinkered with.

Thanks again.

104
Views
0
Helpful
3
Replies
CreatePlease to create content