Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Lost Serial interface on 7206

I removed a subinterface from a serial interface on my 7206VXR, 12.1(1)E5. Now the whole serial interface is gone. I tried reinstalling the controller. It takes the commands but after a write mem, it does not show up, nor does the serial interface. Ant ideas?

Thanks,

M

  • Other Network Infrastructure Subjects
4 REPLIES
New Member

Re: Lost Serial interface on 7206

Was it an actual serial port ?

the reason I ask this is that it may be an E1 controller card which is associated with a logical seral port.

If so then under the Controller config you will need to associate your timeslots with a channel group, e.g.

Controller E1 3/0

channel-group 0 timeslots 1-31

I would now have Serial 3/0:0

Hope that helps

John

Bronze

Re: Lost Serial interface on 7206

Mitchel,

Do you see the port adapter in the output of a 'show diag'?

-Zach

New Member

Re: Lost Serial interface on 7206

Have you tried a reload?

New Member

Re: Lost Serial interface on 7206

Well it is running in an environment were this is not desirable. The strange thing is when I came to work the next morning it was there. Very strange.

88
Views
0
Helpful
4
Replies