09-19-2002 02:26 PM - edited 03-02-2019 01:29 AM
I removed a subinterface from a serial interface on my 7206VXR, 12.1(1)E5. Now the whole serial interface is gone. I tried reinstalling the controller. It takes the commands but after a write mem, it does not show up, nor does the serial interface. Ant ideas?
Thanks,
M
09-19-2002 11:44 PM
Was it an actual serial port ?
the reason I ask this is that it may be an E1 controller card which is associated with a logical seral port.
If so then under the Controller config you will need to associate your timeslots with a channel group, e.g.
Controller E1 3/0
channel-group 0 timeslots 1-31
I would now have Serial 3/0:0
Hope that helps
John
09-20-2002 09:48 PM
Mitchel,
Do you see the port adapter in the output of a 'show diag'?
-Zach
09-21-2002 10:34 AM
Have you tried a reload?
09-21-2002 12:30 PM
Well it is running in an environment were this is not desirable. The strange thing is when I came to work the next morning it was there. Very strange.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide