Currently I have a 2620 router in Johannesburb with two low speed serial interface cards. There is a E1 circuit connected to S0/0. We are running a Frame Relay point to point. The CIR/EIR values are 768/768. However even when running well below the CIR I am getting high output aborts.
Why would there be a low speed serial interface installed as this is a high speed line? Could this have been a mistake? Should I look into upgrading to a high speed card?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.