Lucent MAX 3000's and Cisco 803 PPP Multilink issues
I have a bit of a problem that I need to really sort out. I have completed upgrading two Lucent MAX 3000's, added the stacking commands, and stacked them into one system. I then had the carrier set up the 3 ISDN30's to cyclical dialling. I have one small problem. The remote Cisco 803's dialling up to the MAX's seem to be dropping B channels. The 803's are doing PPP Multilink. What happens is that every 5 minutes or so, the Cisco's drop one B channel and then the next. The Cisco then needs to place another call immediately after. My question is, what could be causing the Cisco's to drop their calls? Are there any compatibility issues with the MAXen stack? BTW, before stacking was enabled, the PPP Multilink calls from the Cisco's worked fine. If need be I will elaborate the technical bits and pieces when necessary.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...