Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

MACL's and VACL's

Trying to create Mac based ACL's on 6500 Layer 2 switch card. Trying to limit devices connecting to a security video camera. Try to apply to port camer is on and can only apply it to inbound, no option for outbound.

Then tried to apply MAC ACL on Vlan #, outbound.

The result is that non-identified devices can still access the camera?????

I can't apply IP ACL's because the end devices are DHCP.

What are my options???

1 REPLY
Silver

Re: MACL's and VACL's

You can also try to filter the traffic based on MAC address on a specific vlan statically usign the command Router(config)# mac-address-table static 0050.3e8d.6400 vlan 12 drop.Refer the following URL for more info

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/secure.htm#wp1074871

146
Views
0
Helpful
1
Replies
CreatePlease to create content