Management Addresses between Cat4k Sup-3 and Sup-2 boxes
I have 2 cat4006's trunked together via dot1q, working fine. The one with the Sup-3 is VTP server, the Sup-2 is VTP client. I get a proper address via DHCP from the Sup-2 box so that is working fine. However I cannot ping one box from the other via the Mgt addresses which are on the same subnet. The VLANs are being sent to the client box fine as shown by a "show vlan". But it does not show the IP's assigned to the VLANs in the Sup-3 box???
On the Sup-2 box, I am using int me1. On the Sup-3 box, I have VLAN 1 setup with an address in the same subnet. What do I need to do to ping and Telnet between these boxes?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...