If I want to change the management vlan on a catalyst 3550 from vlan 1 to some other vlan, is it simply enough to shut down vlan 1 and create a new vlan, for example vlan 20, and assign it an ip address? Or do I need to configure something else? If so, what and where....?
Don't forget that there are lots of management traffic that travels only on VLAN1 like CDP, STP etc. My personal experience always have been using VLAN1 as management and everything else in other VLANs.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...