Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Management VLAN on the 2950

I would like to set up my management VLAN as 10 on my 2950 not 1 but the switch keeps reverting back to 1. I heard there was a command or way to over ride this and have 10 as my amnagement VLAN vice 1.

4 REPLIES
Cisco Employee

Re: Management VLAN on the 2950

Just shutdown interface VLAN1 and give an IP address to interface VLAN10

http://www.cisco.com/warp/public/473/8.html#Configuremgt2900

New Member

Re: Management VLAN on the 2950

I have found that you have to enable clustering in order to change the management VLAN. Did you have to do the same thing? It doesnt make much sense as to why that would be the case, I just know it worked!

Any direction would be helpful.

New Member

Re: Management VLAN on the 2950

!

interface VLAN1

no ip directed-broadcast

no ip route-cache

shutdown

!

interface VLAN10

ip address 1.1.1.1 255.255.255.0

no ip directed-broadcast

no ip route-cache

!

New Member

Re: Management VLAN on the 2950

Newbie,

Back in the old days when we used 2924XL-ENs there was a command that would designate your management interface. Oddly enough, the command is {management}. Create your interface, appl your IP address and issue the command {management}, this should take care of your problem. Let me know how this turns out.

-Bo (LENG Life Experienced Network Geek}

353
Views
0
Helpful
4
Replies
CreatePlease login to create content