Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Management Vlan

I am experiencing the following problem at a client site any suggestion on how to resolve this problem would be greatly appreciated.

The client has got 2 Cat6509 core switches, there is a

cat4507R with a Sup4 hanging off these two core switches. These switches are

connected via dot1q trunks. All inter vlan routing is being done on the two

Cat6509 core switches. On the Cat4507R there is a "interface vlan 1"

with ip address 10.0.24.1, we have lost connectivety to this address. On the

trunks the native vlan is vlan 1. All other devices in all the other vlans on

this switch including other devices in vlan 1 still have full connectivity.

The uplink ports form the Cat4507 to the Cat6500's is Gig1/1 and Gig 2/1.

We have removed vlan 1 from the trunk on Gig 1/1 to force it to go over Gig2/1

but this had no effect on the connectivity to 10.0.1.24. If you connect via the

console to the Cat4507 and ping 10.0.1.24 the ping is successfull, if you

connect a pc to vlan 1 on the cat4507 and ping 10.0.1.24 it is unsuccessfull.

A "shut" and "no shut" performed on "int vlan 1"

does not solve the problem, we also removed the ip address from vlan 1 and

then put it back again after 10min but this did not work either.

So in short, only connectivity to "int vlan 1" has been lost all

other devices connected to the cat4507 are working even other devices that are

connected to vlan 1 and are connected to the cat4507.

3 REPLIES

Re: Management Vlan

HI

As u say that u r having two uplinks from gig1/1 and gig2/1 to the core switches so it means that u have redundant connections.can y verify among these two ports which one is blocking and which one is forwarding.i think it is related to some STP issue.

Thanks

Mahmood

Blue

Re: Management Vlan

does the 4507 switch show vlan1 as active?

could be prunned across the trunk. verify what the trunk is supporting in terms of what vlans.

send config and show spanning-tree for more input. (keep sensitive ip addys out)

Bronze

Re: Management Vlan

Is the SVI still up/up? If so, are you trying to get to the interface from within the same subnet? If not, have you checked the default route for this subnet, making sure that proper routing is taking place?

99
Views
0
Helpful
3
Replies