Hi - I would like to add a cluster of 2950s to a network of Baystack hubs and 450T switches. I can add the IP information to the command switch and set up the cluster using CMS. However, when I connect this clust to my main network (to Bay 450T) I am unable to access the command switch through IP. I can't even 'ping' the switch. The cluster appears to work fine as I can connect a PC to any port and connect to any other device on the main network - it just seems as though the internal IP has shut down on the 2950. Can you help?
Re: Managing 2950 cluster in a mixed vendor network
There are no vlans specifically defined in the Bay equipment, other than what may be there by default. I have the problem even when my PC is plugged directly into the 2950 - I can't 'ping' the 2950 even though PC and 2950 have consecutive IP addresses. I'll check the vlan interface again on the 2950, though I'm pretty sure I checked this before and it's up.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...