Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Managing Aironet AP350 with cw2k

I´ve got problems to manage AP350 with cw2000. New package is installed. I can only configure the read community in the AP350, but for communication cw2k needs the write community. What´s tehe problem ??

I look forward to your reply,

thank you very much

Adi

3 REPLIES
Blue

Re: Managing Aironet AP350 with cw2k

If this AP350 is running VxWorks, then the User that you created is the SNMP string. Depending upon the what specific capability settings you have enabled for this user will make it a RO, RW or both.

If the APs are running 11.x code, read-only needs "snmp + admin + firmware" rights.

- If the APs are running 12.x code, read-only needs "snmp + admin" rights.

New Member

Re: Managing Aironet AP350 with cw2k

Hi

Thank you very much.

I have only another problem. to save the running- and startup- files from the AP´s, wich settings i need ?? the device status say´s "telnet is not supported".

Thank´s in advance

Adi

Blue

Re: Managing Aironet AP350 with cw2k

APs running VxWorks have no concept of a start-up and a running config. It's just like CatOS where everything is running config.

89
Views
0
Helpful
3
Replies