I have three routers that are connected via a 768k frame relay network. Each router has two frame relay permanent virtual circuits (PVC). I configured traffic shaping to optimize my congestion and control the flow of traffic. I was told by MCI that each PVC is burstable to the full 768k, depending on congestion. I would like to take advantage of excess burst size (Be), but Im not sure how to configure it. Based on my configurations below, do you believe that I could take advantage of my Be? I would greatly appreciate any suggestions that would help maximize my performance.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.