We have got a customer with a couple of 3620's running back to back with a 8Mg HISSI interface to provide a WAN link between their two sites.
The routers are only configured with 10Mg ethernet cards which connect back to there loacl switches.
My question is, in theory, how much traffic can a 10 mg interface (running full duplex) take before it starts getting errors ?. There is already a high number of input errors on that interface and was wondering if it was the through put which was causing it. FYI, Its currently running at between 3-6 Mg of traffic.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...