I'm trying to help a non-profit org that has gotten a MC3810V from a donation and needs to set it up for their T1. The 3810 has only the T1 controller, a Serial 0 and 1, an Ethernet, and the internal switch. The T1 is a frame relay circuit with DLCI 16.
I have the IP addresses for the upstream router and the one for my interface but I'm unable to get it going. I don't know how to correctly set up the serial 0 to talk via the t1 controller. Any help would be appreciated. I feel close to the non-profit org because we adopted our boy through them.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.