MC3810V insufficient resources to create channel group
I'm trying to help a non-profit org that has gotten a MC3810V from a donation and needs to set it up for their T1. The 3810 has only the T1 controller, a Serial 0 and 1, an Ethernet, and the internal switch. The T1 is a frame relay circuit with DLCI 16.
So far, I have figured out that I need to cross connect the serial to the t1 controller but when I try to create a channel group, I get: Insufficient resources.
Am I on the right track here?
I have the IP addresses for the upstream router and the one for my interface but I'm unable to get it going. I don't know how to correctly set up the serial 0 to talk via the t1 controller. Any help would be appreciated. I feel close to the non-profit org because we adopted our boy through them.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...