Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Meaning of "DS0's Active High Water Mark"

Correct me if I'm wrong:

The command: show controller E1 call-counters states some counters like:

DS0's Active High Water Mark ( per controller )

System's DS0's Active High Water Mark

So, if I want to check if I need to upgrade my incoming lines then I only need to compare the System's DS0's Active High Water Mark with my maximum number of incoming lines, correct ?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Meaning of "DS0's Active High Water Mark"

You are right. The "Total DS0's Active High Water Mark" SHOULD be the maximum number of DS0s that were active at once, since the last reload or clearing of counters.

1 REPLY
Silver

Re: Meaning of "DS0's Active High Water Mark"

You are right. The "Total DS0's Active High Water Mark" SHOULD be the maximum number of DS0s that were active at once, since the last reload or clearing of counters.

367
Views
0
Helpful
1
Replies
CreatePlease to create content