we have recently put in some 2xT1 MLPPP links to replace existing FR links. In most cases, telco provides us with identical circuit paths for each T1 in the bundle. On this particular MLPPP bundle, we requested diverse paths for each T1 in the bundle. As such, each T1 is diverse in both path and telco loop.
We have noticed that latency across this MLPPP link is almost indentical to the frame links and we feel that the point-to-point circuits should have lower latency than the FR links based on the FR circuits' cumulative path through the frame cloud (coast to coast).
Because these T1s are diverse, I understand that latency across the MLPPP interface is measured as the average of the latency across both T1s, as packets are load balanced between the 2 Ts in the bundle.
I could take down each T1 and measure latency across the single T, but is there any way to see the individual stats (latency included) on the T1s while both Ts are operational on the bundle? This bundle terminates on a FlexWan card on a 6509 running IOS
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...