Re: Measuring inbound and outbound IP traffic in bytes on CISCO
all you have to do is use a standard SNMP mib browser. You want to monitor the object ID of 188.8.131.52.184.108.40.206.1.10 which is IfInOctecs and the object ID of 220.127.116.11.18.104.22.168.1.16 which is IfOutOctets. This will let you monitor inbound and outbound traffic. Set this on your outside interface of the router. I use the program What's Up with its snmp graphing utilitie.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...